Exhaust filter changing, Warning, Exhaust filter hepa – Kenmore 116.22813 User Manual
Page 16: Power-mate® care, Power»mate® care, L warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EXHAUST FILTER CHANGING
WARNING
Fire and/or Electrical Shock Hazard
Do not operate with a clogged
exhaust filter or without the exhaust
filter or exhaust filter cover installed.
EXHAUST FILTER
HEPA
The exhaust filter cartridge must be
replaced when dirty. Replace the filter when
the entire surface area is covered evenly.
The filter CANNOT be washed as it will
lose its dust trapping ability,
NOTE: See PARTS AND FEATURES for
Exhaust Filter Number
1, Pul! up on
the exhaust fil
ter cover to
remove from
the motor cover
and lay aside.
Exhaust
Filter
Cover-
2. SHghtiy push
the exhaust filter
cartridge to the
side, as shown in
the illustration,
and pull up to
remove.
3. Replace the
exhaust filter car
tridge, carefully
positioning it so
that the side
shown in the
iilustration goes
down under the
ribs. Then push
the other side
down until it snaps into place. Place the new
filler into the motor cover with the grey
edge down.
4. Replace the
exhaust filter
cover by engag
ing the two tabs
on the rear and
pushing down in
front until it
snaps closed.
POWER-MATE® CARE
Always follow all safety precautions when
cleaning and servicing the Power-Mate®.
!l WARNING
Electrical Shock Or Persona! Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec
trical shock or personal injury from
cleaner suddenly starling.
16