beautypg.com

Belt changing and agitator cleaning, To clean agitator, Caution – Kenmore 116.22813 User Manual

Page 17: Important

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

BELT CHANGING AND AGITATOR CLEANING

CAUTION

When you remove the end caps, a
small metal washer on each end

may come off. DO NOT lose these
two metal washers.

TO CLEAN AGITATOR:

NOTE; in order to keep cleaning efficiency
high and to prevent damage to your vacu­
um, the agitator must be cleaned every time
the belt is changed.

The agitator must also be cleaned accord­

ing to the following schedule:

Vacuum Use

HEAVY -

(used daily)

MODERATE -

(used 2-3 times/week)

LIGHT -

(used 1 time/week)

Clean Agitator

every week

every month

every 2 months

Remove any dirt or debris in the belt path
area or in the brush roller area.

Carefully remove any string or debris
located on the agitator, end caps, wash­
ers or agitator shaft.

IMPORTANT

Replace the
washers and
the end caps.
See the explod­
ed view for cor­
rect
assembly.

Disconnect cleaner from electrical outlet.

Check and remove hair, string and lint build­

up frequently in the Power-Mate® agitator
and end cap areas, if build-up becomes
excessive, disconnect Power-Mate® from

wand and follow the steps below.

TO REMOVE BELT

1. Turn Power­
Mate® upside

down.

2.

Unscrew the

two (2) Power­

Mate cover
screws.

3.

Turn Power­

Mate® right
side up. Press
handle release
pedal and
lower the
swivel. Lift rear

latches up.

4.

To remove cover,

grasp the sides and
pul! out.

5. Depress tabs
on rear of
agitator cover
and rotate
forward to

release from the
Power-Mate®
base.

AgHaior

Cover

6. Lift agitator

assembly out
and remove
worn belt.

End Cap

7, Slide end caps off
to check and clean

end cap areas. See

AGITATOR
ASSEMBLY for

picture of complete
agitator assembly.

End Cap

17

This manual is related to the following products: