Kenmore 119.16312800 - Manual (Page 23)

MANUALLY LIGHTING THE BURNERS WITH
THE MATCH HOLDER
MANUALLY LIGHTING THE SIDE BURNER
OR THE BACK BURNER
1. Open the lid.
2. Ensure all burners are in the "OFF" position.
3. Slowly turn on the gas at the LP cylinder
valve if it is not already on.
4. Place a match In the match light stick. This is
located inside the left cabinet door.
5. Use the stick to slide the lit match through
the cooking grates and the front of the heat
diffuser to the burner you wish to light.
6 . Press and turn the burner control knob to
"Hi". Continue to push in and hold up to 5
seconds or until the burner lights.
7. If the burner does not light within 5 seconds,
turn the burner control knob to
"OFF". Wait 5 minutes for gas to clear, and try
again.
8 . When lit, turn the control knob to the desired
heat setting.
1. Open the grill lid or side burner cover.
2. Ensure the control knob is in the "OFF"
position as well as any main burner not in
use.
3. Slowly turn on the gas if it is not already
on.
4. Strike the match, and place near the top
of the burner.
5. Turn the control knob to "Hi"
6 . If the burner does not light within 5
seconds, turn the burner control knob to
"OFF". Walt 5 minutes for the gas to clear,
and try again.
7. When lit, turn the control knob to the
desired setting.
8 . Continue to press in and hold the back
burner control knob for 5 to 7 seconds
once lit to activate the safety flame
sensor. Failure to do so will cause gas
to be shut off to the back burner and the
burner will go out.
^ A: A A
1. Do not use charcoal briquettes, lava rock, Never lean over the grill cooking area while
or any type of ceramic product In this grill. lighting your gas grill. Keep your face and body
2. Do not put a barbecue cover or other a safe distance (at least 18 inches) from the
flammable material in the storage area of lighting hole and burners when lighting your
this grill. grill with a match.
23