Side burner and back burner lighting instructions – Kenmore 119.16312800 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

USE AND CARE INSTRUCTIONS

Grill Lighting Instructions

Before each use, check all hoses for cracks,
nicks, cuts, or abrasions. If a hose is

damaged in any way, do not use your grill

before replacing the hose with an authorized
part from the Parts List. Also make sure all

gas supply connections are securely

tightened.

Familiarize yourself with the Safety and Use

and Care instructions in this manual. Do not
smoke while lighting the grill or checking gas
supply connections.

Be sure the LP gas tank has gas.

Open the grill lid.

Back Burner

Electric Igniter

Failure to replace a faulty hose, secure gas

supply connections, or to open the lid before

proceeding to the Lighting Procedures could
result In a fire or explosion that could cause

serious bodily Injury, death, or property damage.

Set control knobs to OFF and open the LP
gas tank valve SLOWLY.

Push and turn any control knob to Hi

Low

Immediately press the electronic Igniter
button for 3-5 seconds to light the burner.

You should hear a clicking sound which

shows the electronic ignition is working. If

the burner does not light within 5 seconds,
turn the burner control knob to "OFF". Wait 5

minutes for the gas to clear, and repeat the

above procedure.
Once one burner Is lit, the adjacent burner
can be lit by turning Its control knob to Hi.

When lit, turn the control knob to Its desired
setting.

Side Burner and Back Burner Lighting
Instructions

1. Follow steps 1 through 4 of the Grill Lighting

Instructions.

2. Open the grill lid or side burner cover.

3. Set control knobs to OFF and open the LP

gas tank valve SLOWLY

4. Push and turn the control knob to "Hi".

5. Immediately press the electric igniter button

for 3-5 seconds to light the burner. You
should hear a clicking sound which shows
the electronic ignition Is working.

If the burner does not light within 5 seconds,

turn the burner control knob to "OFF". Wait

5 minutes for the gas to clear, and repeat the
above procedure.

7. Continue to press in and hold the back

burner control knob for 5 to 7 seconds once
lit to activate the safety flame

sensor. Failure to do so will cause gas to be
shut off to the back burner and the burner
will go out.