Install side shelf frame to firebox – Kenmore 119.16312800 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attach Side Burner Control Knob and Side Burner Ignition Wire
□
Slide the side burner ignition wire through the hole located in the lower left front corner of the
Firebox Assembly and over the side burner igniter connector. See Insets 1 and 2.
□
Push the Control Knob onto the valve stem. See Inset 3.
Side Burner Control Knob
Qty: 1
Install Side Shelf Frame to Firebox
□
Unscrew the 2 Phillips Head bolts V
4
" from the upper left and right corner holes In the right side of
the firebox as shown in Inset 1. The bolts extending out of the firebox sides are to attach the side
shelf frame.
□
Slide the upper holes of the side shelf frame over the heads of the 2 Phillips Head Bolts and drop
down.
□
Use 2 Phillips Head Bolts (M
6
xl
6
mm) and 2 Washers (M
6
) to attach the lower holes In the side shelf
frame to the firebox as shown in Inset 2. Tighten the upper bolts after the 2
lower bolts are tight.
□
Use 2 Phillips Head Bolts (M4x8mm) and 2 Lock Washers (M4) to attach the lower holes in the Side
Shelf Front Panel to the firebox. See Inset 3.
Phillips Head Bolt MSxlSmm
Qty: 2
Lock Washer: M
6
Qty: 2
Phillips Head Bolt M4xSmm
Qty: 2
LOCK
Washer M4
Qty: 2
Inset 2
Inset 3