Place and secure lp cylinder into the cabinet, Install battery – Kenmore 119.163018 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Place and Secure LP Cylinder into the Cabinet
□
Hook the ends of the Cylinder Support Ring into the two holes In the left front and rear legs.
See Inset 1.
□
Place the LP cylinder down Into the tank support hole In the bottom of the cabinet. Ensure the valve
faces to the front. Wrap the Cylinder Support Ring around the top of the tank and hook to secure the
LP cylinder in place. See Inset 2.
□
Unscrew the bolt and nut located on the front of the left side cabinet panel. Attach the regulator
hose support ring, located on the regulator hose, to the left side cabinet panel using the same bolt
and nut. See Inset 3.
Do Not Hook Up the LP Cylinder to the Regulator Assembly at this time.
Inset 1
Inset 2
Inset 3
Install Battery
□ Unscrew the electronic igniter cap. Place the "AA" Battery into the igniter with the positive ( + ) end up.
Screw the electronic Igniter cap back Into place.
Battery (Size AA)
Qty: 1
17