Kenmore 790.4101 - Manual (Page 41)

Storage Drawer with extensible glides
To remove Storage Drawer:
1. Open the drawer to the fully opened position.
2. Locate the latches on both sides of the warmer drawer. (See Figure 1)
3. Pull up on the left glide latch and push down on the right glide latch. (See Figure
1 )
4. Pull the drawer away from the range.
5. To clean warmer drawer, gently scour with a soapy scouring pad, this will
remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If
necessary, cover difficult spots with an ammonia-soaked paper towel for 30
to 40 minutes. Rinse with clean water and a damp cloth. Remove all cleaners
or the porcelain may become damaged during future heating. DO NOT use
spray oven cleaners on the cooktop.
To Replace Storage Drawer:
1. Align the glide latches on both sides of the drawer with the slots on the drawer.
2. Push the drawer back into the range.
General Care & Cleaning (cont’d)
Changing the Oven Light
ik CAUTION Be sure the oven is unplugged and all parts are COOL before replacing the oven
light bulb. Do notturnthe oven light on during the self-cleaning cycle. High temperature will reduce
lamp life._______________________________________________________________________
The interior oven light will turn on automatically when the oven door is opened.
The oven lights may also be manually operated by pressing the ( ^ ) pad.
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield,
change bulb and be sure to replace glass shield.
41