Kenmore 790.4101 - Manual (Page 17)

Setting Oven Controls
Setting the Clock
The (^) pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Fig. 1). Figure 1
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press (^). "CLO" will appear in the display (Figure 2).
2. Press pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press "CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold (^) for 7 seconds. "CLO" will appear in the
display. "12h" (Figure 5) or "24h" (Figure 6) appears in the
display and the control beeps once.
2. Press to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press START to accept the change or press ( stop ) to reject the
PRESS DISPLAY
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours.
®(D®
for 7 seconds
START or ( STOP
Figure 2
on r i n
J U L L U
Figure 3
Figure 4
Figure 5
Figure 6
17