beautypg.com

To operate the dual surface element, A caution, Setting surface controls (cont’d) – Kenmore 790.4101 User Manual

Page 11: Hi lo

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Operating the Dual Surface Element

The cooktop is equipped with two Dual radiant surface
elements located at the right and left front cooktop position

(Figure 1). Indicator lights on the control panel at that position

are used to indicate what portions of the Dual radiant element
will heat. The INNER light indicates that only the inner
element will heat (Figure 2). The OUTER light indicates that
both inner and outer elements will heat together (Figure 3).
You may switch between these different settings at any time
during cooking.

To Operate the Dual Surface Element:

1. Place correctly sized cookware on the radiant surface element.

2. Touch and hold the

pad for the Dual element position until a beep is

heard. The display will show " - -". Note: If no further pads are touched within
10 seconds the request to power the element ON will clear.
Select the INNER (Figure 2) or OUTER (both elements) (Figure 3) to heat by

Setting Surface Controls (cont’d)

3.

4.

5.

I

nner

O

uter

Figure 2

O

uter

I

nner

Figure 3

pressing the f‘'sizE

7 pad once or twice times (Figures 3 & 4 show indicator

lights with OUTER selected). Note: If no element size is chosen when the dual
element is turned ON, the control will default to the inner coil only.

Touch HI

pad once to turn ON the power level to HI. Touch Lo

pad once for Lo (See Figure 4).

Each touch of the HI

or L

o

(2) pad will increase or decrease power

levels from 9.5 through 3.0 by .5 increments. Simmer power levels between 3.0

and 1.2 will decrease or increase by .2 increments. Lo is the lowest power

level available.
Note: The power level may be adjusted at any time while the element is ON.

Hi

Lo

\

O

uter

INNER

E

lement

S

ize

E

r-’;

....

6

.

Figure 4

When cooking has been completed touch the 0503 pad once to turn the entire

element OFF.

Each dual surface element provides a constant amount of heat at each setting.

The different glow of the 2 elements is normal and doesn’t affect heating
performance (See Figure 3). A glowing red surface heating area extending

beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

Note: If no element size is chosen when the dual element is turned ON, the control will default to the inner coil only. See
page 9 for recommended surface cooking settings.

Note: The Hot Element message will remain displayed on the control panel as long as the element is still hot and will
remain ON until the heating surface area has cooled sufficiently.

ik CAUTION

I Radiant surface elements may appear to have cooled after they have been turned off. The glass surface

may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

A CAUTION

I

Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or

plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden
spoons could catch fire if placed too close to the surface elements.

11