Kenmore 790.4101 - Manual (Page 13)

To Set the Cooktop Lockout Feature Q
cooktop
The clock (^) pad is used to activate the Cooktop Lockout feature which will lock all surface elements from being
accidentally turned ON. This feature will only lock the cooktop.
Setting Surface Controls (cont’d)
INSTRUCTIONS
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold (^) until "CLO" appears (Figure 1). Continue
holding until a second beep sounds (after 3 seconds). If a triple beep
sounds instead, check all surface elements and turn them to the OFF
position and repeat this step. Q will appear in the display indicating
the cooktop controls and functions are locked out until the cooktop is
unlocked (See Figure 2).
To turn the Cooktop Lockout Feature OFF:
1. Press and hold (^) until "CLO" appears. Continue holding until a
second beep sounds (after 3 seconds). Q will disappear from the
display indicating the cooktop may be used normally (See Figure 3).
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop
Lockout feature. The cooktop will remain locked until the Self-Clean
cycle has completed and the oven door has unlocked. If a power failure
occurs after the Cooktop Lockout has been activated, you must turn
OFF the Cooktop Lockout feature before being able to use the cooktop
features again.
PRESS DISPLAY
Figure 1
lOn
I - J U
■
Figure 2
on
Ou
Figure 3
How the Electronic Surface Element Controls work when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that all
electronic surface element control displays show “Sb”. The surface elements can be used even if the Sabbath Feature is
on.
To turn ON a Surface Element when the Oven Sabbath Feature is active:
If you turn on a surface element when the oven Sabbath feature is on, the electronic surface element control will record
that request and execute it with a 15-30 seconds delay. So the element will start heating 15-30 seconds after the surface
element control was turned on. As the oven control, the surface element display will not show the setting because “Sb” is
on in the displays. When necessary, it is possible to adjust the power of the surface element but you have to remember
that the surface element control will adjust the temperature with the same delay.
To turn OFF the Surface Element when the Oven Sabbath Mode is active:
To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element will
immediately turn off without any delay.
Note: Referto page 32-33 to activate the Sabbath Feature.
13