Important safety instructions – Kenmore 911.94752 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SAVE THESE INSTRUCTIONS
Read all Instructions before using this appliance. When using gas
or electrical appliances, basic safety precautions should be followed,
Including the following:
Step 1
Locating the bracket
A. Locate the bracket against the
rear wali and either the right or left
cabinet if the countertop
overhangs the cabinet, offset the
bracket from the cabinet by the
amount of overhang. If there is no
adjacent cabinet, position the edge
of the bracket at the desired
location of the range side panel
Use the bracket as a template
and mark 2 hole positions on the
vyall and 2 hole positions on the
floor. Use either the v/ood or
concrete floor set of positions,
depending on your floor type.
See Fig. 1
IMPORTANT SAFETY INSTRUCTIONS
Ail Ranges Can Tip
Injury to Persons
Could Result
Install AntkTip
Device Packed
With Range
See installation
Instructions
o
These ANTI-TIP bracket installation
instructions are for wood or concrete
floors and walls. Any other type of
construction may require special
insíaílaíion techniques to provide
adequate fastening of the ANTI-TIP
bracket to the floor and wail.
The use of this bracket does not
prevent tipping of the range when
bracket is not properly installed
NOTE: The installation of the
ANTI-TIP bracket must meet all
local codes for securing appliance..
Adjacent Cabinet or
Final Location of Range
Side Panel
continued on next page