Kenmore 665.75832 - Manual (Page 36)

CARING FOR YOUR RANGE
REMOVING THE OVEN DOOR (contd.)
2. Hold oven door so that the top edge of each
hinge hanger is horizontal. Insert hinge hangers
into the front frame hinge slots.
3. Tilt top of door toward range. Slide hinge
hangers down onto front frame support pins.
NOTE: Make sure the hinge hangers are fully
seated and engaged on the support pins.
4. Insert the door stop clip with the angular surface
at the top of the frame hinge siot, then push in
the bottom of the clip until flanges are flush with
the front frame.
5. Open the door compietely and remove the door
removai pins. Save door removai pins for future
use.
6
.
Close the door.
7. Check for alignment to make sure door is
instailed eveniy.
Door stop
clip "—
Range
Door removal
pin hole ----------
Door removal
pin hole
Hinge
hanger
Support pins
Front frame
hinge slot
Angular
“"'surface of
door stop
clip
THE OVEN LIGHT
The oven light will come on when you open the
oven door. The oven light will not work during the
Self-Cieaning cycle.
To turn the figlil
door IS eloseè
• Press the OVEN pad.
fliO
I jiven J
To repiaeo I ^
1. Unplug range or disconnect power.
2. Remove the giass bulb cover in the back of the
oven by turning it
counterclockwise.
-— tí :
4. Repiace the light bulb cover by turning it clockwise.
3. Remove the light bulb from its socket by turning
it counterclockwise. Replace the bulb with a
40-watt appliance bulb.
5. Plug in range or reconnect power.
36