The oven vent, Mmmb, The warming drawee – Kenmore 665.75832 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

USING YOUR RANGE
USING THE WARM & READY WARMING DRAWER
(contd.)
To
mmmB
the warming drawee
Remove all items from inside the warming drawer
and allow the unit to cooi compietely before
attempting to remove the drawer.
1.
Puii drawer to its fuii open position.
r
I
2. Locate the black triangle tabs on each side of
the drawer.
To replace the warming drawer«
1. Align the drawer glides with the receiving
guides.
3. Press the tab DOWN on the RIGHT side and iift
the tab UP on the LEFT side at the same time.
Then pull drawer out another inch.
2. Push drawer in completely.
3. Gently open and close drawer to ensure it Is
seated properly on the slides.
4.
Carefully pull the drawer all the way out holding
on to the sides, not the drawer front.
THE OVEN VENT
Hot air and moisture escape from the oven through
a vent that is near the middle of the backguard. The
vent lets air circulate properly. Be careful not to
block the vent, or you will get poor baking/roasting
results.
NOTE:
Never store plastics, paper, or other items
that could melt or burn near the oven vent, or any
of the surface burners.
26