Warning, Caution – Kenmore 116.36932 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE LIGHT BULB
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect eiectrical supply before
performing maintenance to the
vacuum cleaner. Failure to do so
could result in electrical shock or
personal injury from the vacuum
cleaner suddenly starting.
TO REMOVE LIGHT BULB
1, Disconnect power cord from eleofricai
outlet.
2. Press han
dle release
pedal and lay
vacuum clean
er back.
3. Pry tight
lens out af
slots as shown
on bolh sides.
Rotate lens up
and lift off.
CAUTION
Do not USB a bulb rated over 9W (13V).
During extended use, heat from the
bulb could overheat surrounding plas
tic parts.
4. Remove the light
bulb by pulling
straight out.
5. Carefully insert
new light bulb fully
mlo slot.
Note: See PARTS AND FEATURES for
bulb number.
^
caution
Do not plug In or turn on until the vacu
um cleaner is compieteiy reassembled.
6. To replace light
lens, place tab at
front of lens Into
slot. Rotate lens
down and firmly
snap into place.
20