Primary filter removal and cleaning, Warning, To replace primary filter – Kenmore 116.36932 User Manual
Page 18: Primary filter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PRIMARY FILTER REMOVAL AND CLEANING
^WARNING
Electrical Shock And Personal Injury
I I C Z
h i
O I M
Unplug power cord from electrical out
let. Do not operate the vacuum cleaner
without the primary or exhaust fiiters. Be
sure the fiiters are properly installed to
prevent motor failure and or electrical
shock.
PRIMARY FILTER
Check primary filter frequently and clean
when dirty.
TO REMOVE PRIMARY FILTER
Remove the dust bin assembly as outlined
in the DUST BIN CLEANING section.
Make sure dust bin is free of debris before
removing lid and filter. Rotate dust bin lid
assembly counterclockwise as indicated on
the lid and lift off.
Turn This Direction
To Open For Emptying
Closed
While holding dust bin lid over a trash con
tainer grasp primary filter, rotate counter
clockwise and lift off.
Clean primary fitter by gently tapping over a
trash container. Tap on several sides to
ensure best cleaning.
Dust Bin
Lid
Cleaning
,0-
Filler
Remove primary
filter by turning
it counterclock
wise and pulling
out (See arrows
on bottom of fil
ter).
Rinse with
water only as
needed,
do not
use any deter
gent or soap.
Allow the filter to dry for 24 hours before
putting it back into the vacuum cleaner.
When cleaning the filter no longer restores
vacuum cleaner's suction to full power you
need to replace the filter.
Note: See PARTS AND FEATURES
for the filter number.
TO REPLACE PRIMARY FILTER
To replace filter, insert it over cleaning
cams as far as it will go. Make sure rubber
seal at top of filter is flush against filter sup
porter, then turn filter clockwise to secure
into place. Filter will click and snap when it
is secured into place.
Note:
Under normal use and care, your fil
ter can be expected to last up to 5 years.
. Rubber
denning Seal-
Cems
Fitter
Filter—»
Filter-^
Supporter/ '
Dust Bin
Lid
Re-assemble dust bin lid to dust bin, see To
py31" m|i4 yy
18