Kenmore 116.28014 - Manual (Page 18)

4. Repiace the
exhaust filter
cartridge. Place
the new filter into
the canister with
the foam seal
towards the
canister.
5. To replace the
exhaust filter
cover place the
y^\^S/ofs
two tabs on the /#k fi^A
filter cover into
the slots on the
canister. ,
6. While holding
latch down
rotate filter cover
into place.
7. Release latch and verify that filter cover
is locked Into place.
Afthough the dirt sensor feature in your
Kenmore canister is designed for years of
trouble free use, the passage of dirt through
the air passage system can coat the lens
causing the green light to come on and stay on
- never switching to red. When this happens
the tenses must be cleaned.
I CAUTION
Never use water or any cleaning solution
when cleaning the lenses. The residue of
the water or cleaners will accelerate the
recoating of the lenses and make
IIviviioSisdil y inIwrii#Iliii n
TO CLEAN THE LENSES
- Handle
1. Remove the
Lock
\-L,r i
handle by pressing fiUifOn—K 1
the handle quick
Handle ’
—
release button. Quick
iieiesss—
A
i
Sensor
Lenses
2. As indicated by the illustration, the two dirt
sensor lenses are located on the inside of the
handle, approximately 5 inches/130 mm down
(note the arrows). These lenses should be
cleaned periodically. To reach the sensor
lenses, use a small brush such as a bottle
brush. Brush each sensor lens several times to
remove dust and dirt.
18