Kenmore 116.28014 - Manual (Page 14)

PERFORMANCE FEATÍIRÉS
WARNING
Persona! Injury Hazard
Always turn off and unplug the vacuum
cleaner before cleaning the agitator area
as agitator may suddenly restart.
Failure to do so can result in personal
injury.
OVERLOAD PROTECTOR
Overload Protector/
Belt Reset
Button—
The PowerMate
has built-in
protection against
motor and belt
damage should
the agitator jam. If
the agitator slows
down or stops, the
overload protector
shuts off the
PowerMate and
the red light will come on. The canister
motor will continue to run.
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction, then
press BELT RESET button.
If the problem persists, have the
vacuum cleaner serviced by a Sears or
other qualified service agent.
E iMb ftMr H fMW J|L |L I
mm
ijiip f^l FДMPR
Active brush edge
cleaners are on both
sides of the
PowerMate- Guide
either side of the
PowerMate along
base »boards or next
to furniture to help
remove dirt trapped
at carpet edges.
PERTOHMANCE INDICATOR
Performance
Indicator-
Wheji th^vacuum
clever p running
witl/noTOal airflow,
f ligly on the
irformance
idicalor Is off. The
light mmes on
wh^ver the
airipw becomes blocked. If that occurs,
chfck the disposable dust bag, motor
fly filter and other possible clog
locations shown in HOW YOUR VACUUM
^CLEANER WORKS.
To corr^moblem: See the TROUBLE­
SHOOTING tibie.
NOT^S^iB light may come on when using
cerif^ttachmenis, due to reduced airflow
thmim attachment,
Í rivial protector
ftm vacuum cleaner has a thermal
fprllector which automaticaliy trips to protect
№ vacuum cleaner from overheating, If a
*og prevents the normal flow of air to the
lotor, the thermal protector turns the
^motor off automatically. This allows the
' motor to cool in order to prevent possible
damage to the vacuum cleaner.
To correct problem: Turn off and unplug
vacuum cleaner to allow the vacuum
cleaner to cool and the thermal protector
Check for and remove clogs, If
ne^ssary. Also check and replace any
c^ged filters. Wait approximately
ilrty (30) minutes and plug the vacuum
cleaner In and turn back on to see If the
motor protector has reset.
14