Kenmore 116.28014 - Manual (Page 17)

MOTOR SAFETY FILTER CHANGING
A WARNING
QHnPir Hi37i4rH
t^Wtl i «# m I nCviCinfU
Turn off and unplug vacuum cleaner
from electrical outlet. Do not operate
the vacuum cleaner without the motor
eafptv filtpr R f > eurA fhp filter ¡ q rirv Anri
properly installed to prevent motor
failure and/or electrical shock.
MOTOR SAFETY FILTER
ELECTROSTATIC
This filter must be replaced when dirty. It
should be replaced regularly depending on
use conditions. The filter CANNOT be
washed as it will lose its dust trapping
ability.
NOTE: See PARTS AND FEATURES for
Motor Safety Filter number
1. Remove the bag as outlined in the BAG
CHANGING section,
2. Lift the rubber
retainer and pull out
motor safety filter as
shown
3, Replace the fiiter,
white side out,
facing the dust bag,
by sliding it back
into place under the
ribs in the bag
cavity Tuck filter in
so that it fits
completely under the
rubber retainer.
4, Replace the bag as outlined in the BAG
CHANGING section.
EXHAUST FILTER CHANGING
A
WARNING
Fire and/or Electrical Shock Hazard
Do not operate with a clogged exhaust
filter or without the exhaust filter
installed. Do not operate without filter
cover installed.
EXHAUST FILTER
HEPA
The exhaust fiiter cartridge must be
replaced when dirty. Replace the fiiter when
the entire surface area is covered evenly.
The fiiter CANNOT be washed as it will
lose its dust trapping ability.
NOTE: See PARTS AND FEATURES for
exhaust filter number.
1. Press latch
down to release
the exhaust filter
cover from slot in
canister.
Latch-
FHier
Cover
2. Puli fiiter
cover outward to
remove from
canister.
3. Remove the
exhaust filter
using the recess
as shown.
17