Kenmore 385.11607 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2. PREPARE THE MACHINE FOR SEWING
Set Up the Machine (Continued)
• Free-Arm Sewing: the Removable
Extension Table
• Accessory Storage Box
■ Change the Presser Foot
Choose the Needle and Thread
• To Change the Needle
(for free-arm sewing)
1.
Grip the table with your index finger
and thumb, as shown.
2.
Pull gently to the left. The extension
table will snap out.
To Attach the Extension Table
(for flat-bed sewing)
1.
Insert the tab and the pin into their
catches.
2.
With your thumb and index finger,
gently snap in.
box lifts open toward you.
Sewing
accessories
are
conveni
ently located in the box.
the stitch you wish to sew.
To
change
the
various
presser
feet, raise the presser bar to its
highest
position
by
lifting
the
presser foot lever.
Loosen
the
presser
foot
thumb
screw,
choose
the
proper
foot,
insert from the bottom.
Tighten
the
screw
using
the
large
screw
driver
to
make
certain the foot is secure.
NOTE:
Raise
the
needle
bar
to
its
highest
position
by
turning
the
hand
wheel
toward you.
1.
Loosen
the
needle
clamp
screw
by
turning it toward you.
2.
Remove
the
needle
by
pulling
it
down
ward.
3.
Insert
the
new
needle
into
the
needle
clamp with the flat side away from you.
4.
Push the needle up as far as it will go.
5.
Tighten
the
needle
clamp
screw
firmly
with
the
large
screwdriver
from
the
accessory box.