Kenmore 385.11607 User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 3. LEARN THE STITCHES
• Sew a Button
Set the Machine
Stitch
Zigzag foot
Stitch selector
iimtiiii
Top thread tension
control 1 to 4
(Model 12614)
J_
Diluii«
(Model 11607)
Stitch length control
any number (not
necessary to adjust)
-3-
Darning plate
Use the darning plate for button sewing (see p. 22).
1
.
2
.
4.
5.
Set the stitch selector at " ci
3
Align both holes of the button with the slot of the foot and place the left
hole of the button just below the needle point.
Lower
the
foot
and
turn
the
stitch
selector
to
zigzag
until
the
needle
point
comes just above the right hole of the button.
Sew about five stitches and raise needle.
Set the stitch selector at " c'o ” again and sew a few stitches to lock thread.
To
strengthen
the
shank,
cut
the
threads leaving a 20 cm (8") tail. Bring
the
needle
thread
down
through
the
hole in the button and wind it around
the shank.
Draw
the
thread
to
the
bottom
side
and knot.
26