Stk17ta8, Register map detail – Cypress AutoStore STK17TA8 User Manual

Page 19

STK17TA8

Document #: 001-52039 Rev. **

Page 19 of 23

0x1FFF7

Watchdog Timer

WDS

WDW

WDT

WDS

Watchdog Strobe. Setting this bit to 1 reloads and restarts the watchdog timer. The bit is cleared automatically

once the watchdog timer is reset. The WDS bit is write only. Reading it always will return a 0.

WDW

Watchdog Write Enable. Set this bit to 1 to disable writing of the watchdog time-out value (WDT5-WDT0). This

allows the user to strobe the watchdog stobe bit without disturbing the time-out value. Set this bit to 0 to allow bits

5-0 to be written.

WDT

Watchdog time-out selection. The watchdog timer interval is selected by the 6-bit value in this register. It represents

a multiplier of the 32 Hz count (31.25 ms). The range of time-out values is 31.25 ms (a setting of 1) to 2 seconds

(setting of 3Fh). Setting the watchdog timer register to 0 disables the timer. These bits can be written only if the

WDW bit was cleared to 0 on a previous cycle.

0x1FFF6

Interrupt

WIE

AIE

PFIE

ABE

H/L

P/L

WIE

Watchdog Interrupt Enable. When set to 1 and a watchdog time-out occurs, the watchdog timer drives the INT pin

as well as setting the WDF flag. When set to 0, the watchdog time-out only sets the WDF flag.

AIE

Alarm Interrupt Enable. When set to 1, the alarm match drives the INT pin as well as setting the AF flag. When set

to 0, the alarm match only affects the AF flag.

PFIE

Power-Fail Enable. When set to 1, a power failure drives the INT pin as well as setting the PF flag. When set to 0,

the power failure only sets the PF flag.

Reserved For Future Used

H/L

High/Low. When set to a 1, the INT pin is driven active high. When set to 0, the INT pin is open drain, active low.

P/L

Pulse/Level. When set to a 1, the INT pin is driven active (determined by H/L) by an interrupt source for approxi-

mately 200 ms. When set to a 0, the INT pin is driven to an active level (as set by H/L) until the Flags register is read.

0x1FFF5

Alarm – Day

10s Alarm Date

Alarm Date

Contains the alarm value for the date of the month and the mask bit to select or deselect the date value.

Match. Setting this bit to 0 causes the date value to be used in the alarm match. Setting this bit to 1 causes the

match circuit to ignore the date value.

0x1FFF4

Alarm – Hours

10s Alarm Hours

Alarm Hours

Contains the alarm value for the hours and the mask bit to select or deselect the hours value.

Match. Setting this bit to 0 causes the hours value to be used in the alarm match. Setting this bit to 1 causes the

match circuit to ignore the hours value.