GE CGS990SETSS - Manual (Page 52)

GEAppliances.com
Problem Possible Causes What To Do
LOG shows in the
display The Gas/Control Lockout feature
is activated.
• Be sure the surface burner controls are turned OFF.
Turn this feature off to use the range. See the Gas/Control
Lockout section.
Display goes blank A fuse in your home may be
blown or the circuit breaker
tripped.
• Replace the fuse or reset the circuit breaker.
The clock is in the
blackout mode.
• See the Special features of your oven control section.
Display flashes Power failure. • Reset the clock.
Unable to get the
display to show "SF" Oven control pads were
not pressed properly. • The Bake and Broil Hi/Lo pads must be touched at
the same time and held for 3 seconds.
Power outage,
clock flashes Power outage or surge. • Reset the clock. If the oven was in use, you must reset
it by touching the Clear/Off pad, setting the clock
and resetting any cooking function.
"Burning" or "oily"
odor emitting from
the vent This is normal in a new oven
and will disappear in time.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
Strong odor An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
• This is temporary.
Fan noise (some models) A cooling fan or a convection fan
(depending on the function you
are using) may automatically turn
on. • This is normal. The cooling fan will turn on to cool internal
parts. It may run up to 1-1/2 hrs after the oven is turned
off. The convection fan will cycle on and off until the
function is over or the door is opened.
Convection fan not
working (some models) Preheat temperature
not reached. • Fan will start automatically once the preheat
temperature is reached.
5 2