Cabinetry – GE ZET1SMSS User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Cabinetry
A7
Single Oven Cutout
for Installation Below
a Monogram Advantium
or Microwave Oven
A8
Single Oven Cutoutfor
Installation Between a
Monogram Advantium or
Microwave Oven anda
Monogram Warming Drawer
Per Advantium or
Microwave Oven
Requirement
2" (5.1 cm) Min.
Per Advantium or
Microwave Oven
Requirement
Note:
Install the oven
only with specific
models listed on the
label located on top of
the oven.
NOTE: The middle rail separating the two
openings may need to be larger than the
2"
(5.1 cm) minimum shown. Always refer to the
individual installation instructions pocked with
each product for specific requirements.
Combined Advantium or
Microwave Oven and Wall Oven
Installation:
When installed in combination with a
Monogram single wall oven, use separate electri-
coljunction boxes.
• Refer to the Advantium or microwave
oven installation instructions for electrical
requirements ofthat product.
• These connections must be made
by a qualified electrician. All electrical
connections must meet National Electrical
Code or prevailing local codes.
2" (5.1 cm) Min.
2" (5.1 cm) Min.
PerWarming Drawer
Requirement
NOTE: Additional clearances may be required.
Check to be sure the oven supports above the
Warming Drawer
do not obstruct the required interior depth and
height. The middle rail separating the openings
may need to be larger than the
2"
(5.1 cm) minimum shown. Always refer to the
individual installation instructions pocked with
each product for specific requirements.
Warming Drawer Combined with
Advantium or Microwave Oven
and Single Oven:
Install a separate 120V, 60Hz, properly ground
ed receptacle. See installation
instructions pocked with each product
for specific requirements.