Carl Goldberg GBGA1085 - Manual (Page 16)

16
1. C OLLECT THE FOLLOWING PARTS
(1)
SERVO WITH MOUNTING SCREWS
(1)EZ
CONNECTOR WITH NUT AND SCREW
THROTTLE SERVO INSTALLATION
2. Install the throttle servo as shown above.
3. Place the EZ connector on the throttle servo
arm just as you did earlier.
Slide the throttle pushrod through the EZ con-
nector and adjust as necessary.
1. † G
ATHER THE FOLLOWING ITEMS
(1)
FUEL TANK
(1)
RUBBER TANK STOPPER
(1)
CLUNK
(1) 3
MM X
25
MM SCREW
(1) CAP WASHER LARGE
(1)
CAP WASHER SMALL
(1) 3
MM X
40
MM BRASS TUBE
(1) 3
MM X
60
MM BRASS TUBE
(1)
SILICONE TUBE
4
MM X
80
MM
(2)
SILICONE TUBE
5
MM X
165
MM
2. † Insert the 3mm screw through the center
hole in the large washer, through the center
hole in the rubber washer against the large
side, and screw the small washer on the
back side.
FUEL TANK ASSEMBLY
3. † Insert the brass tubes through two of the
holes. They should be arranged so as the long
one will be on the right side of the plane and
the short one on the left side.
† The tubes should extend out the front of the
cap 5/8”. Bend the long tube up at about a 20
degree angle. This should be adjusted so the
end of the tube almost touches the top of the
tank when installed.
4, † Install the 4mm silicone tube to the short
brass tube and install the clunk to the other
end of the silicone tube. This is the fuel pick-
up and must be free to “flop” around in the
tank so it can pick up fuel in any attitude.
5. † Install the assembly into the tank so the vent
tube is turned up to the top of the tank and is
positioned on the right side of the tank.
Tighten the screw to expand the rubber cap.
Don’t over tighten or you could split the tank.