Carl Goldberg GBGA1085 User Manual
Page 15
15
4.
Mark the location of the engine mounting
holes.
Also at this time mark the location of where
the throttle pushrod should exit the firewall.
Remove the engine and the motor mount
plate.
5.
Drill the engine mounting holes in the plate.
6.
Drill the hole for the engine throttle pushrod.
7.
Mix up a small amount of 20 minute epoxy
and spread it on the fuselage beams and the
motor mount plate.
Keeping the plate upright, re-install it into the
fuselage.
allow the epoxy to dry.
8.
After the epoxy has dried, re-drill the motor
mount screw holes in the plate.
Slide the throttle pushrod tubing into the hole
in the firewall that you drilled earlier.
Push the tube through the fuel tank compart-
ment and through the small hole on the side of
the former.
re-install the motor using the screws.
Hole
9.
Make a 1/4” bend at the end of the throttle
pushrod and connect the push rod to the throt-
tle arm on the motor.
Slide a swivel keeper in place over the
pushrod and snap in place.
Move the throttle open and close to make sure
you have clearance. If you do have enough
clearance then cut away some of the fuselage
sides to make enough clearance.
THROTTLE PUSH ROD INSTALLATION
1.
C
OLLECT THE FOLLOWING PARTS
(1) 1.5
MM X
40
CM
(4) #6
X
3/4
SHEET METAL SCREWS