Carl Goldberg GBGA1087 - Manual (Page 6)

6
4. Install the control horn in the slot making sure
that it is about 1/32” past the top surface of the
aileron. Make sure the holes are aligned over
the hinge line of the aileron.
5. Using thin CA, apply one drop on each side of
the control horn.
6. Flip the wing over and glue the aileron horn
from the top side of the wing using thin CA.
7. Repeat for the other aileron.
8. Locate the string, soft wire or a cable tie. Push
it into the aileron servo cut out and fish it out
the hole in the middle of the wing on the top
side.
9. Tape one leg of the servo y-connector to the
cable tie, string or soft wire.