Carl Goldberg GBGA1087 - Manual (Page 3)

3
ITEMS NEEDED TO COMPLETE THIS AIRCRAFT
1 RADIO GUIDANCE SYSTEM (4 CHANNEL
MINIMUM REQUIRED WITH 4 SERVOS)
1 6” SERVO “Y” HARNESS
1 ELECTRONIC SPEED CONTROL
(ELECTRIC FLY C-20 FROM GREAT
PLANES SUGGESTED)
1 NIMH 7C 650AAA BATTERY (2 OR 3 CELL
2100 MAH LI-PO BATTERY SUGGESTED)
1 CA ACCELERATOR
1 1 OZ. BOTTLE CA MEDIUM GLUE
1 1/2 OZ. BOTTLE CA THIN GLUE
1 5 MINUET EPOXY
1 1/4” FOAM RUBBER
1 400 SIZE MOTOR OR BRUSHLESS
MOTOR EQUIVALENT
1 6 TO 1 GEAR DRIVE
TOOLS AND SUPPLIES FOR ASSEMBLY .
MODELING OR UTILITY KNIFE
WORK SURFACE (24" X48")
SMALL STANDARD & PHILLIPS SCREW-
DRIVERS
MASKING TAPE
NEEDLE NOSE PLIERS
24” RULER
FLEXIBLE STRAIGHT-EDGE
30-60-90° x 6" TRIANGLE
SOFT PENCIL
A FEW STRAIGHT OR "T" PINS
WIRE CUTTER (DYKES)
OPTIONAL HEAT GUN/COVERING IRON
ACID BRUSH
5 FT. LENGTH OF STRING
Caution:
Before starting, care-
fully go over all high
stress areas with an
epoxy or wood glue to
confirm all areas are
well glued.
Important
Information
Covering coming loose is not
COVERED UNDER WARRANTY. Due to tem-
perature changes the plane may develop
some wrinkles in the covering that you will
need to remove with an iron. Be sure to seal
the edges down first so that you do not
cause the covering to shrink and leave
exposed areas of wood. Please inspect the
plane before beginning to assemble to make
sure you are happy with it. After assembly
has begun you cannot return the kit. If you
find a problem before beginning to assemble
the plane you must contact us, please do
not return it to the dealer.