Carl Goldberg GBGA1090 - Manual (Page 13)

13
6. Thread the 4-40 x 4-7/8” double threaded rod
into the nylon adjustable control horn.
79. Place a 4-40 hex nut and a metal clevis on
the other end of the threaded rod.
8. Mount the clevis to the servo arm and place
the clevis clip on th clevis.
9. Repeat 1 thru 8 for the second aileron servo.
4. Insert the nut through the aileron servo hole
and let the nut fall through the wing and out the
hole at the root.
5. Mount your servo using the hardware sup-
plied with the radio.
Mounting Wing to Fuselage
1. Insert the tube into one of the wing halves.
2. Trial fit each side of the wing through the fuse-
lage.
3. Lightly sand the tube openings if necessary.
4. Drill and tap the wing to the tube one side at
the time (Keep the wing tight to the fuselage).
5. Before flying place clear plastic tape over
the screw holes to keep the screws from
vibrating out.
Collect the following parts:
(1) Left & Right Wing
(1) 1-1/2” x 25-3/16” Wing Tube
(2)4-40 x 1/2” Bolt
Canopy & Hatch
Collect the following parts:
(1) Canopy
(1) Hatch
(2)4-40 x 1/2” Bolt
1. Place the hatch on the fuselage and secure
using 4-40 x 1/2 bolts.Don’t forget thread lock
2. Cover the fuselage with wax paper around the
hatch area.
8. Glue the canopy to the hatch.
Caution:
Make sure that no glue touches the
fuselage.