Carl Goldberg GPMA0960 Gentle Lady - Manual (Page 2)

2
Items needed to complete this kit.
1 Radio Guidance system( 2 channel
minimum required)
2 Rolls covering material
1 2oz. bottle CA glue
1 CA accelerator
1 30 minute epoxy
1 Tub Balsa-tinted CGP Model Magic™.
1 Box #64 Rubber bands.
1 Servo mounting Tape
1 1/4 x 8 x 12” CGP Foam Padding
CGP Scuff Guard ( To Protect Bottom From
Scratching)
For Removable Tip Option
1 1/8” x 3” x 18” Balsa Sheet
1 Piece 3/32” Dia. x 6” Music Wire
1 3/32” x 6” GCP Nylon Reinforcing Tape
For Engine Power
Engine, Propeller, Mounting Screws, Nuts, and
Washers
For Servo Mounting
CGP #360 Pushrod Connectors
Selecting Radio Control
Equipment
Radio sets are battery powered with either dry cells or the more
reliable, rechargeable nickel-cadmium (ni-cad) batteries.
Although ni-cad powered units are more expensive, the cost of
routinely replacing worn out batteries may be much higher in the
long run. Many of the radio systems now available feature
“servo reversing” switches which allow you to reverse the
response of the servo. This simplifies radio installation and is
worth considering. Exponential or dual rates are popular features
which , if used properly, can help smooth out the flight of a sen-
sitive model. Your local hobby dealer should be able to help you
select the proper radio for your needs and skill level. And be
sure to get a system designed for aircraft, as only certain fre-
quencies are available for model aircraft.
Necessary Tools and Supplies.
Miscellaneous Rubber Bands
Roll of waxed Paper
Modeling Knife and Single Edge Razor Blade
Sandpaper( assorted grits, including Medium(150) and
Fine(220-320)
Sanding Block
“T” Pins (at least 50)
Building Board (24”x70”)
Electric Drill
1/16” Drill Bit
1/8” Drill Bit
Allen Wrench (.050 for #4 socket set screw)
Small Screwdriver (1/8” Blade Tip)
Covering Iron and Heat Gun
Masking Tape
Pliers
Flexible Straight-Edge
30-60 Degree x 6” Triangle
Pencil
Limited Warranty
Carl Goldberg Models takes pride in the care and attention given
to the manufacture of components for its model airplane kits.
The company warrants replacement of any materials found to be
defective for their intended use, prior to their use in construc-
tion of the aircraft, provided the buyers requests such replace-
ment within a one year period from the date of purchase and
provided the defective part is returned, if so requested by the
company.
No other warranty, expressed or implied, is made by the
company with respect to this kit. The buyer hereby assumes full
responsibility for the risk and all liability for personal or proper-
ty damage or injury arising out of the buyer’s use of the compo-
nents of this kit.