Braeburn 2220 - Manual (Page 9)

8
6 Setting Your Program Schedule
Setting the Time and Day
1. In normal operating mode, press the DAY/TIME
button. The display will switch to the day/time
setting mode and the hour will be flashing.
2. Press or to adjust the hour.
Press
DAY/TIME.
3. Press or to adjust the minute. Press
DAY/TIME.
4. Press or to adjust the day of the week. Press RETURN to exit.
Extended Hold Period*
(User Option 4)
The Extended Hold Period lets you select the period your thermostat will
hold the temperature when the HOLD mode is activated (See “Temperature
Adjustment”). When LNG is selected the thermostat will hold your
temperature indefinitely. When 24HR is selected, the thermostat will hold
your temperature for 24 hours and then return to the current program at
that time.
Service Filter Monitor
(User Option 5)
The Service Filter Monitor is a user selectable
service monitor that will display a reminder for
a required air filter replacement by flashing the
SERVICE FILTER segment in the display. When the
selected interval has been reached, and required
cleaning or replacement has been performed,
touch the
RETURN button to reset the timer and reset the service monitor.
Select OFF or a set number of days before the reminder will appear.
Adaptive Recovery Mode (early recovery)*
(User Option 6)
Adaptive Recovery Mode is a user setting that controls when the thermostat
will start to recover from setback.
Tips Before Setting Your Program Schedule
• Make sure your current time and day of the week are set correctly.
• When programming, make sure the AM and PM indicators are correct.
• Your NIGHT event cannot exceed 11:50 p.m.
This thermostat has been configured with one of the following
programming options:
• 7 day programming mode with 4 events per day (default)
• 5-2 (weekday/weekend) programming mode with 4 events per day.
• Non-Programmable mode
ARM TM Setting Result
OFF Start change at programmed time
ON Finish change at programmed time
*Not available if User Option 1 is set to non-programmable