Braeburn 2220NC - Manual (Page 11)

7 Operating Your Thermostat
Setting the System Control Mode
The System Control has several modes of
operation that can be selected by moving the
SYSTEM switch to the appropriate position.
COOL Only your cooling system will operate
OFF Heating and cooling systems are off
HEAT Only your heating system will operate
Additional Switch Position (Model 2220NC Only):
EMER Operates a backup heat source (Emergency Heat) for heat pump
systems only
NOTE: If your model 2220NC was configured
for a conventional system (CONV) then you will
not have the EMER (emergency heat) option
and “NO EMER SET” will flash in the display if
EMER is selected with the system switch.
Setting the Fan Control Mode
The Fan Control has 2 modes of operation – AUTO and ON. The mode can
be selected by moving the FAN switch to the appropriate position.
AUTO The system fan will run only when your
heating or cooling system is running
ON The system fan stays on
Temperature Adjustment
Temporary Adjustment – Press the or button to adjust the current
set point temperature.
Extended Adjustment – Press the HOLD button so that HOLD appears in
the display screen. Press or to adjust the current set temperature
(See “Extended Hold Period”, page 8).
10