ALTANA LCM III - Manual (Page 33)

32
Standard Operations
6. Insert the sample cuvette/cell.
For the use of 11 mm round vials the measurement starts
automatically.
For the use of square cuvettes/sample cells in the cell
compartment #2, press Measure to start the measurement.
7. The result of the color calculation is displayed.
Note: The control bar displayed on the right of the displayed result
shows the relationship of the measurement result to the measuring
range.
8. For the next measurement, remove the cuvette/sample cell and
insert the next sample cuvette/cell or press Measure to
measure the same sample again.
5.5.1.1 Touch-sensitive areas on the measurement window
On the screen are touch-sensitive areas where the user has
immediate access to special software options.
Figure 5 Touch-sensitive areas on the measurement window
1 Open Operator ID to change or add operator ID
(see section
5.2.1 on page 16 )
4 Change the displayed color scale to the next color
system which is selected in the Operator ID color
scale list for display. (see section
5.5.1.3 on page
33 )
2 Open Sample ID to change or add sample ID
(see section 5.2.2 on page 17 )
5 Change Date & Time (see section 5.2.3 on page
18 )
3 Open Select Color Scale and select scale for
display (see section
5.5.1.3 on page 33 )
6 Open Power Management to indicate the charge
status of the battery in %. (see section
5.2.5 on
page 19 )