Agasio A622W - Manual (Page 50)

[email protected] Page | 49 713-893-4514
18. Alarm Settings
Figure 18.1 – An example of the Alarm Settings page along with the enabled scheduler
As shown above, there are two different modes for alarm settings. The first mode is motion detection,
which can be seen above. The sensitivity of motion detection can be adjusted easily according to your
requirements. If you need higher sensitivity for the alarm settings, the number should be lower. We
recommend placing the number on “5.”
The second mode is the input alarm, which when connected, triggers an alarm through the alarm input
signal. This is usually connected to a linkage alarm GPIO.
When triggered, there are three different alarm modes. The first is IO alarm linkage, where the camera is
connected with linkage directly t
o the alarm box through GPIO and sounds the alarm’s siren. The second
alarm mode is e-mail notification, which sends e-mails with attached images that have been captured
during the motion detection. The last mode is the upload of alarm pictures, which refers to the FTP server
being sent the images, and the images can also be sent consistently at an interval, which is set on the
FTP Service Setting’s page.
The built-in scheduler refers to the time frame that the camera will be armed. Each box in the scheduler
refers to a 15 minute time frame for each hour in the day and for every day of the week.
“0” refers to
12:00 AM and “13 – 23” refers to 1:00 – 11:00 PM.