AERCO Modulex High Pressure Manual User Manual
Gas fired boiler systems, Installation, operation & maintenance instructions, Gf-115h
Table of contents
Document Outline
- 1 - GENERAL DESCRIPTION
- 1.1 – TECHNICAL FEATURES
- 1.2 - CODE AND STANDARDS APPROVALS
- 1.3 INSTALLATION FLEXIBILITY
- 1.4 DIMENSIONS AND WEIGHTS
- 1.5 - TECHNICAL DATA (THE NAME PLATE IS PLACED UNDER THE FRONT JACKET NEXT TO THE CONTROL PANEL.)
- 1.6 MODULEX SIDE VIEW SHOWING MAIN COMPONENTS
- 1.7 BOILER FREEZE PROTECTION
- 2 - INSTRUCTIONS FOR INSTALLERS
- 2.1 INTRODUCTION
- 2.2 INSTALLATION INSTRUCTIONS
- 2.3 DATA PLATE
- 3 - GENERAL INFORMATION FOR VENTING
- 3.1 VENT PIPE CONNECTION
- 3.2 GAS VENT CATEGORIES
- 3.3 INSTALLATION AND SIZING
- 4 - PIPING
- 4.1 MAKEUP WATER QUALITY
- 4.2 - MAXIMUM ALLOWABLE WORKING PRESSURE
- 4.3 BOILER LOOP DESIGN GUIDELINES
- 4.4 CSD-1 MANIFOLD ASSEMBLY (SUPPLIED)
- 4.5 CONNECTING SUPPLY AND RETURN PIPING (PER ANSI Z21.13A)
- 4.6 SYSTEM FILLING & DRAINING
- 4.7 NOTES ON CONDENSATE DRAIN
- 4.8 GAS MAINS AND CONNECTIONS
- 5 - ELECTRICAL
- 5.1 ELECTRICAL CONNECTIONS
- 5.2 DHW STORAGE TANK
- 5.3 ENABLE/ DISABLE
- 5.4 INSTALLATION OF SENSORS
- 6 - BOILER OPERATION
- 6.1 GENERAL DESCRIPTION AND OPERATION
- 6.2 MODULATION THEORY
- 6.3 IGNITION SEQUENCE
- 6.4 MODES OF OPERATION
- 6.5 MODULEX BOILER INITIAL STARTUP
- 6.6 UNIT REASSEMBLY
- 7 - MAINTENANCE
- APPENDIX A - TEMPERATURE SENSOR RESISTANCE CHARTS
- APPENDIX B - MODULEX PARTS LIST