Acura 2008 RDX - Owner's Manual - Manual (Page 252)

If you just
received your vehicle and have not
trained any of the buttons in
HomeLink before, you should erase
any previously learned codes before
training the first button.
To do this, press and hold the two
outside buttons on the HomeLink
transceiver for about 20 seconds,
until the red indicator flashes.
Release the buttons, then proceed to
step 1.
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time.
If you are training the second or
third buttons, go directly to step 1.
Hold the end of the garage door
opener remote transmitter 1 to 3
inches from HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink. If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 4.
If the red indicator in HomeLink
continues to flash slowly (does
not flash rapidly), your remote
transmitter may stop
transmitting after a short time.
Go to step 3.
Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time. While continuing to hold the
HomeLink button, press and
release the remote transmitter
button every 2 seconds.
If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons, and go to step 4.
If the red indicator in HomeLink
continues to flash slowly (does
not begin to flash rapidly),
repeat steps 1 thru 3.
Test the HomeLink button by
pushing it for about 1 second.
If the button works,
programming is complete.
If the button does not work go
to step 5.
1.
2.
3.
4.
HomeLink Universal Transceiver
Training HomeLink
Bef ore you begin
248
2008 RDX
Table Of Contents Main Menu