Acura 2008 RDX - Owner's Manual - Manual (Page 151)

Not pressing a memory button
within 5 seconds.
Readjusting the seat position.
Readjusting the outside mirror
position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
To select a memorized position, do
this:
To stop the system’s automatic
adjustment, do any of these actions:
Push any of the adjustment
switches for the seat.
Shift out of Park.
Adjust the outside mirrors.
Make sure the vehicle is parked.
Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
Doing any of the following after
pressing the SET button will cancel
the storing procedure.
The system will move the seat and
outside mirrors to the memorized
positions. The indicator in the
selected memory button will flash
during movement. When the
adjustments are complete, you will
hear two beeps, and the indicator will
remain on.
Press any button on the control
panel: SET, 1, or 2.
If desired, you can use the
adjustment switches to change the
positions of the seat or outside
mirrors after they are in their
memorized position. If you change
the memorized position, the
indicator in the memory button will
go out. To keep this driving position
for later use, you must store it in the
driving position memory.
1.
2.
Selecting a Memorized Position
Driving Position Memory System
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
147
2008 RDX
Table Of Contents Main Menu