Audio system – Acura 2008 RDX - Owner's Manual User Manual

Page 189

The scan function gives

you a sampling of all channels while
in the channel mode. In the category
mode, only the channels within that
category are scanned. To activate
scan, press the SCAN button. The
system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again.

To store a channel:

Pick a preset number for the
channel you want to store. Press
and hold the appropriate side of
the preset bar until you hear a
beep.

Repeat steps 2 and 3 to store the
first six channels.

Press the

button again.

The other XM band will be shown.
Store the next six channels by
repeating steps 2 and 3.

Once a channel is stored, press and
release the proper side of the preset
bar to tune to it.

For information, see page

You can store up to 12

preset channels using each side of
the preset bar. Each side of the bar
stores one channel from the XM1
band and one channel from the XM2
band.

In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected.

Use the tune, seek, or scan
function to tune to a desired
channel.

Press the

button. Either

XM1 or XM2 will be shown on the
center display.

186

228

SCAN

XM Satellite Radio Reception

Adjusting the Sound

Preset

Audio System

Fe
a

185

2008 RDX

Table Of Contents

Main Menu