Kofax Communication Server 10.0.0 User Manual

Page 71

Environment Guide

Version 10.00.00

ipv6 nat v6v4 source fd96:eb5f:7508:5760:204:23ff:feac:4172 172.20.148.53
ipv6 nat prefix FD96::/96
!

Cisco router 28xx configuration using dynamic IPv4-mapped NAT-PT:

This configuration allows each IPv6 only host to talk with any of the IPv4 only hosts by:

1. Defining the pool/range of IPv4 addresses as IPv

4 “proxy” addresses for IPv6 hosts (in the example

below 172.20.148.53

– 172.20.148.62 with the prefix length 24, which corresponds with IPv4 mask

255.255.255.0)

2. Configuring the NAT-

PT prefix to be “v4-mapped” – it means that each IPv6 address

FD96::AABB:CCDD would be translated to IPv4 address determined by last 32 bits AABB:CCDD. With
our example, in order to reach LS1‟s address 172.20.148.6 KCS core would send the IPv6 packet to
the destination address FD96::AC14:9406

! Global settings
!
Ipv6 unicast-routing
no ipv6 cef
!
! Interface related settings
!
! IPv4 interface
interface GigabitEthernet0/0
ip address 172.20.148.35 255.255.255.0
duplex auto
speed auto
ipv6 nat
!
! IPv6 interface
interface GigabitEthernet0/1
no ip address
duplex auto
speed auto
ipv6 address FD96:EB5F:7508:5760::/64 eui-64
ipv6 nat
no ipv6 redirects
!
! NAT-PT configuration
ipv6 nat v6v4 source list nat_traffic pool ipv6_2_ipv4
ipv6 nat v6v4 pool ipv6_2_ipv4 172.20.148.53 172.20.148.62 prefix-length 24
ipv6 nat prefix FD96::/96 v4-mapped nat_traffic
!
ipv6 access-list nat_traffic
permit ipv6 any FD96::/96
!

KCS core and LS1 configuration using NAT-PT:

1. Given the LS1 is properly setup to listen on particular IPv4 address (like 172.20.148.6 in the example

above) there is no need to configure anything as for NAT-PT

2. In the KCS c

ore simply configure the corresponding “proxy” IPv6 address of the LS1, instead of its IPv4

address

Common Cisco NAT-PT pitfalls:

1. NAT-PT translation is not supported in Cisco Express Forwarding (CEF).

The CEF must be disabled by the command no ipv6 cef (see examples above).