Kofax Export Connector for ERP 2.4.9 - Manual (Page 55)

Kofax Export Connector for ERP Administrator's Guide 55
Chapter 5
XFT Queue Manager
Use function module Z_DICOM_STORE_XFT to configure Kofax Export Connector
for ERP (KEC-ERP) to work with the XFT Queue Manager. (www.xft.de). The
Z_DICOM_STORE_XFT function module rearranges Kofax Capture parameters to suit XFT
and calls the XFT function module.
Before you configure SAP, follow the steps in these sections:
▪
Creating and Configuring a Batch Class - Initial Steps on page 9
▪ Configuring a Store using XFT Queue Manager
Customizing SAP
KEC-ERP uses the remote function module Z_DICOM_STORE_XFT to write data into an XFT
queue. Each document in the XFT queue has one entry. This entry releases all of the index
values in a key/value table. As displayed in the following diagram, Kofax Capture calls an
intermediate function, Z_DICOM_STORE_XFT, that interacts with the original XFT function
to create a queue entry.
No additional SAP configuration is required.
Content Repository with More than Two Characters
SAP ArchiveLink content repository names have a maximum length of two characters.
However, because no ArchiveLink functions are used to communicate with XFT, the content
repository name can be up to 30 characters. Content repository names are case sensitive.
1 Save the content repository with a new name. If you use a name that is longer than two
characters, the system displays the following warning message.