Inovonics EN1252 - Manual (Page 2)

8.14.13 06431D © Inovonics, 2013 - www.inovonics.com
3 Specifications
Dimensions: 3.5x1.7x0.9”
Weight: 1.9 oz
Typical battery life: 1 – 2 years (This does not include current
drawn by external devices)
Internal battery type: 3.0V lithium battery, Inovonics part number
BAT604
RF output power: 24 dBm (250 milliwatts) equivalent isotropically
radiated power
Operating environment: Temperature: -4°F to 140°F using
internal battery (-40°F to 185°F using appropriate external power
source)
Humidity: Up to 90% (non-condensing)
Market: North America
EchoStream® frequency: 902-928 MHz, Frequency hopping
spread spectrum
Regulatory compliance: FCC, Industry Canada, RoHS
Note: Specifications and data are subject to change without
notice.
4 Television and Radio Interference
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
5 Compliance Information
This device complies with part 15 of the FCC Rules and Industry
Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
5.1 Comment to the User
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
5.2 Compliance Notification
The integrator is responsible to ensure the final configuration is
in compliance with the applicable FCC and IC regulations. This
module is limited to battery powered operation only. Connection
to the AC power lines, either directly or through another device,
requires a separate approval from the modular approval
obtained by Inovonics. The integrator is instructed to verify
compliance with the applicable requirements for modular
transmitters. The integrator is responsible for properly labeling
the product containing the module. Product labels must be
permanently affixed on the exterior of the enclosure containing
the module. Labels must include a statement indicating the
product contains the module and the label must specify the FCC
and IC identification numbers:
Example 1: "Contains RF Module - FCC ID: HCQ3B6OT9HPT /
IC ID: 2309A-0T9HPT"
Example 2: "Contains FCC ID: HCQ3B6OT9HPT / IC ID: 2309A-
0T9HPT"
Caution: To maintain compliance to FCC RF exposure
guidelines, install the module at least 20 centimeters (7.8inches)
from the body of the user or nearby persons. The module may
not be co-located with any other transmitters or antennas except
in accordance with FCC multi-transmitter procedures.
6 Warranty and Disclaimer
Inovonics, Inc. ("Inovonics") warrants its products ("Product" or
"Products") to conform to its own specifications and to be free of
defects in materials and workmanship under normal use for a
period of thirty-six (36) months from the date of manufacture.
Within the warranty period, Inovonics will repair or replace, at its
option, all or any part of the warranted Product. Inovonics will not
be responsible for dismantling and/or reinstallation charges. To
exercise the warranty, the User ("User", "Installer" or
"Consumer") must work directly through their authorized
distributor who will be given a Return Material Authorization
("RMA") Number by Inovonics. Details of shipment will be
arranged directly through the authorized distributor.
This warranty is void in cases of improper installation, misuse,
failure to follow installation and operating instructions, alteration,
accident or tampering, and repair by anyone other than
Inovonics.
This warranty is exclusive and expressly in lieu of all other
warranties, obligations or liabilities, whether written, oral,
express, or implied. There is no warranty by Inovonics that
Inovonics product will be merchantable or fit for any particular
purpose, nor is there any other warranty, expressed or implied,
except as such is expressly set forth herein. In no event shall
Inovonics be liable for an incidental, consequential, indirect,
special, or exemplary damages, including but not limited to loss
of profit, revenue or contract, loss of use, cost of down time, or
interruption of business, nor any claim made by distributor's
customers or any other person or entity.
This warranty will not be modified or extended. Inovonics does
not authorize any person to act on its behalf to modify or extend
this warranty. This warranty will apply only to Inovonics Products.
Inovonics will not be liable for any direct, incidental or
consequential damage or loss whatsoever, caused by the
malfunction of Product due to products, accessories, or
attachments of other manufacturers, including batteries, used in
conjunction with Inovonics Products.