Inovonics EN1238D - Manual

© 2011 Inovonics - www.inovonics.com
EN1238D EchoStream
®
Double Condition
Pendant Transmitter
Installation Instructions - 05603D
1 Overview
The EN1238D is a two button pendant transmitter, able to send two
conditions. The EN1238D must be used with an EchoStream
EN4000 or EN4200 serial receiver or the EN6040 network
coordinator. In addition, the application controller (e.g. control
panel) must be designed to accept the two conditions.
1.1 Inovonics Wireless Contact Information
If you have any problems with this procedure, contact Inovonics
Wireless technical services:
• E-mail: [email protected]
• Phone: (800) 782-2709
1.2 EN1238D Components
1.3 EN1238D components
2 Installation and Startup
2.1 Install/Replace the Battery
1. Pry the housing apart at either end and pull the two halves
apart.
2. If replacing a battery, remove the old battery.
3. Install the new battery.
4. Press the Reset button to initialize the transmitter.
2.2 Select the Frequency Band
EchoStream products are able to use a range of radio frequencies,
and must be configured for your geographic area. To configure the
transmitter:
1. Pry the housing apart at either end and pull the two halves
apart.
2. Place a selection jumper on the appropriate frequency band
selection pins.
• Leave the jumper off the pins to set the frequency range to
902-928 MHz for North America.
• Place the jumper on the bottom pins, marked NZ, to set the
frequency range to 921-928 MHz for New Zealand.
• Place the jumper on the top two pins, marked AU, to set the
frequency range to 915-928 MHz for Australia.
3. Press the Reset button to complete configuration.
Caution: When pressing the Reset button, make sure you don’t
also touch the frequency band selection pins. Touching the
frequency band selection pins while pressing the Reset button can
inadvertently set the pendant to the wrong frequency band.
2.3 Register the EN1238D
The EN1238D must be registered with the system in order to be
monitored and supervised. When supervised, the EN1238D will
send a check-in message to the serial receiver or network
coordinator.
Pendants using the 868MHz frequency range for Europe will send a
check-in message every 12 minutes; all other transmitters will send
a check-in message every three minutes.
Each pendant has a unique factory-programmed identification
number. Refer to the control panel’s installation instructions for
details on registering a transmitter.
1. When prompted by the receiver to reset transmitter, press the
Reset button.
2. Replace the cover.
3 Operation
Caution: The EchoStream system should be tested regularly to
ensure operation. To test the system, activate both EN1238D
conditions and ensure an appropriate response.
3.1 Activating EN1238D Conditions
The EN1238D can send two different conditions. To send the first
condition, press and hold either the left or the right pendant button
for one second; to send the second condition, press and hold both
buttons simultaneously for one second.
Condition signals are transmitted multiple times and are indicated
by the blinking transmission LED. When the buttons are released,
the transmitter sends an condition restoral signal.To test a
transmitter, activate the condition by pressing the button(s).
Inovonics Wireless recommends you test the transmitter at least
once per week.
A Reset button B Frequency band selection pins
C Battery
B
A
C
Printing Instructions
1. Print Duplex
2. Align and orient back page to match front
page.
3. Cut on dashed line
4. Fold cutsheet in half along the 8.5" axis.