Hangar 9 Pulse XT 40 ARF - Manual (Page 8)

8
Required Parts
•.Wing.panel.(right.and.left). •.Aileron.(right.and.left)
•.Servo.w/hardware.(2).
•.Clevis.w/retainer.(2)
•.CA.hinge.(8)
•.Servo.extension,.6".(152mm)
•.Aileron.linkage,.4".(102mm).(2)
•.Control.horn.w/backplate.(2)
•.2mm.x.16mm.screw.(4)
•.2mm.x.12mm.screw.(2)
Required Tools and Adhesives
•.Thin.CA. •.Drill
•.Hobby.knife. •.Felt-tipped.pen
•.T-pins. •.Phillips.screwdriver
•.Drill.bit:.1/16".(1.5mm),.5/64".(2mm)
 .  .Step 1
Locate.four.CA.hinges..Place.a.T-pin.in.the.center.of.each.
of.the.four.hinges.
 .  .Step 2
Use.a.1/16".(1.5mm).drill.bit.to.drill.a.hole.in.the.center.of.
each.hinge.slot..Drill.holes.for.both.the.wing.and.aileron.
Note:.The.hole.will.allow.the.CA.to.penetrate.
the.hinge.farther.into.the.surface,.providing.
a.better.bond.between.the.hinge.and.wood.
 .  .Step 3
Slide.the.hinges.into.the.aileron..The.T-pins.will.rest.
against.the.hinge.line.of.the.aileron.
 .  .Step 4
Slide.the.aileron.onto.the.wing..Press.the.aileron..
tightly.against.the.wing,.and.then.remove.the.T-pins..
from.the.hinges.
Section 1: Aileron Installation