Hangar 9 Pulse XT 40 ARF - Manual (Page 12)

12
 .  .Step 18
Use.a.5/64".(2mm).drill.bit.to.drill.the.locations.for.the.
control.horn.screws..Place.a.few.drops.of.thin.CA.into.
each.hole.to.harden.the.underlying.wood..This.will.help.
in.preventing.the.wood.from.crushing.when.tightening.the.
control.horn.screws.
 .  .Step 19
Attach.the.control.horn.using.two.2mm.x.16mm.screws,.a.
2mm.x.12mm.screw.and.the.control.horn.backplate..The.
shorter.screw.goes.towards.the.trailing.edge.of.the.aileron.
 .Step 20
Repeat.Steps.1.through.19.for.the.remaining.wing.panel.
and.aileron.
Section 1: Aileron Installation