Using the device – FRITSCH PULVERISETTE 14 User Manual
Page 34
The flow of source material along the channel is set with the feeder con-
trol unit.
The flow of the source material out of the funnel onto the channel of the
LABORETTE 24 channel has to be adjusted according to the flow proper-
ties of the source material.
n
Set the distance between the funnel and the channel by changing
the height of the funnel so that the "right" amount is fed.
n
If too much is fed, the feeder switches off automatically too often -
slide the funnel somewhat downwards.
n
If too little is fed, the load display remains in the lowest range - slide
the funnel somewhat upwards.
Carry out the installation and removal of the grinding elements as well as
the milling process as described in Ä Chapter 6.3 ‘Installing the grinding
elements’ on page 27, Ä Chapter 6.5 ‘Removing the grinding elements’
on page 29 and Ä Chapter 6.4 ‘Conducting a grinding operation’
Using the device
- 34 -