FRITSCH PULVERISETTE 14 - Manual (Page 28)

NOTICE!
During opening of the housing cover (9), the inner
funnel (13) can fall out to the back.
CAUTION!
The PULVERISETTE 14 may only be operated when all parts
are in place. Neglecting to install parts will result in damage
to the device.
6.4 Conducting a grinding operation
CAUTION!
Wear hearing protection!
Hearing protection should be worn when milling, because
noise levels can reach or exceed 85 dB(A).
After closing the PULVERISETTE 14 as described in , the milling can be
started.
1.
Switch on the PULVERISETTE 14 with the main switch on the back.
2. Press the [SPEED] (+) or (-) keys to set the desired speed.
3. After pressing the [START] key, the PULVERISETTE 14 starts run-
ning.
4. Wait until the mill has ramped up to the set speed.
5. Fill small amounts of the source material into the inner funnel (13,
14).
6. After milling, press the [STOP] key.
7. After the motor has come to a standstill, open the latch (1) and
the housing cover (9).
Using the device
- 28 -