Cub Cadet CC 4BP 32cc - Manual (Page 28)

Blower housing
25
Back pack frame
1. Remove the four nuts that hold the back pack
frame to the shock mounts. See Figure 6.1.
2. Remove the eight screws grip.
3. Carefully separate the grip housings, keeping
the switch and trigger in place. See Figure 6.2.
Figure 6.1
Shock mounts
Figure 6.2
4. Remove the grip housings from the blower tube.
NOTE: Put the two grip housings back together
and secure with a couple of screws to keep the
switch, trigger, wires and cable in place while
working on the blower.
5. Slide back pack off of the blower.
NOTE: If the throttle cable is wire tied to the
back pack mount, cut the wire tie.
CHAPTER 6: BLOWER HOUSING