Cub Cadet CC 4BP 32cc - Manual (Page 11)

Maintenance
8
4. Check the valve lash by placing a feeler gauge
between the rocker arm and the valve stem. To
adjust the valve loosen or tighten the fulcrum nut
with a 8mm wrench until there is a slight drag on
the feeler gauge when you pull it out.
See Figure 2.13.
5. Inspect the gasket that the valve cover sits on for
damage. If it is damaged or compressed replace
it.
6. Reassemble the blower by following steps 1 and
2 in reverse order.
7. Test run the blower in a safe area before return-
ing to service.
Starter
The starter and engine cover are one piece on this
blower. The procedure for removing it are covered in
the spark plug section of this manual.
The rewind spring underneath the starter pulley is
extremely difficult to work with. Because of this, it is not
economical nor is it recommended to try and service
this starter.
Figure 2.13
Feeler gauge
Fulcrum nut
Rocker