COP-USA ALC-WF - Manual (Page 53)

Step I: Construct a platform server (it is necessary to install another set of independent platform
software of our company, and you need to contact our technical support)
Step II: Tick and select『Enable Register on “Center”』
Step III: Set『Center IP』, means the address of platform server
Set『Port』, means the designated port of platform server, and the port is 8889.
Step IV: Set『Device NO.』, means the serial number of platform server (for our product, it does
not need to input the serial number)
Step V: Click『save』, save the parameters
8.15 WIFI Setting
8.15.1 WiFi parameters setting
In NVClient client side, open “Remote Setting” to pop up “Parameters Setting” dialog box, select
“WIFI Setting” option, enable WIFI function in “WIFI Network Parameters” field at the right side,
and set correct network parameters, SSID, encrypt mode, work mode and encrypt content (please
input according to the prompt of document).
Note: before setting WIFI parameters, please ensure that you have installed WIFI
network card on your camera.