ChemoMetec NC-250 - Manual (Page 12)

991-0252 Rev. 1.1 February 2013 12
17. The Install program will now have placed two new icons on your desktop. One is the
NucleoCounter® NC-250™ instrument icon used to launch the NucleoView™ NC-250™ software, the
other is a shortcut to the data folder where NucleoView™ NC-250™ stores application data.
After restart of the PC the NucleoView™ NC-250™ software has successfully been installed.
The NucleoView™ NC-250™ program will now automatically be started and it will guide you through the
instrument installation procedure, if the check mark for ‘Install NucleoCounter® NC-250™ instrument after
Install has finished’ was checked.
Note: Depending on file versions and previous install history, a reboot of the computer may be requested
before the NucleoView™ NC-250™ program is launched. If a reboot is needed, it is essential that you log on
using the same administrator user as used during the above installation.
1. NucleoView™ NC-250™ is now launched in installation guided mode. Click ‘OK’ to continue with
installation of the NucleoCounter® NC-250™ Instrument.
2. Follow the on-screen instructions for the installation of the NucleoCounter® NC-250™ Instrument
using the USB cable and power supply. Note that the instrument icon in the upper left corner of the
application bar is red while no instrument is attached.
3. You will now see a series of pop-up messages from the Windows operating system informing about
driver installations. Among those are:
- A USB hub inside the NucleoCounter® NC-250™ instrument