beautypg.com

Checkline ETMPB User Manual

Page 4

background image

– 4 –

2.3 Turning the Power On and Off

Power On: Press the POWER key until the DISPLAY momentarily shows the tension
range and the software version, e.g. E 1.0, followed by random values or “0.”

Auto Power Off: The tension meter switches off automatically after
3 minutes of non-use.

Manual Switch-Off: Press the POWER key for 5 seconds.

2.4 Reversing the Display

When you shift the tension meter from the right to the left
hand, you can rotate the readings on the DISPLAY by
180°.

Measuring with the left hand:

If you would like to use the left hand for measuring, you should reverse the readings on
the DISPLAY to make them easier to read.

1. Tension meter switched off as described in Chapter 3.3.3.

2. Press and hold the DAMP and POWER keys until the DISPLAY shows the

readings the other way around.

Measuring with the right hand:

1. Tension meter switched off as described above

2. Press and hold the DAMP and POWER keys until
the

DISPLAY shows the readings in the default

(right-handed) orientation.

2.5 Selecting the Unit of Measure

You can set the ETMB to the cN or g unit of measure, depending on the required tension
range. The default setting is cN.

1. Tension meter switched off as described aboveTo select the unit of measure:

2. Press and hold the RECALL and POWER keys until the new unit of measure


is indicated on the DISPLAY.

– 17 –

9.0 SPECIFICATIONS

Calibration

According to factory procedure

Units of Measure

cN / g, user selectable

Accuracy

± 1% FS* ± 1 digit (typical ± 0.5% FS*)

Overrange

10% FS*, without accuracy guarantee

Overload Protection

200% FS*

Measuring Principle

Strain gauge bridge

Meas. Roller Deflection

0.5 mm, max.

Signal Processing

Digital, 24 bit A/D converter

Damping

Adjustable electronical (averaging)

Meas. Frequency

Approx. 1 kHz internal

Display Update Rate

2x per sec.

Display

4-digit LCD, 11 mm high

Memory

Average, last value, maximum, minimum, MAX

PEAK

,

MIN

PEAK

Temperature Coefficient

Gain: less than ± 0.01% FS*/°C

Converter Frequency

30 Hz

Temperature Range

10 - 45° C

Air Humidity

85% RH, max.

Auto Power Off

Automatical after approx. 3 min. of non-use

Power Supply

LiPo accumulator (60 h continouse use, 3 ½ h charging

time) and AC adapter 100 ... 240 V AC with country-

speciic adapters (EU/USA/UK)

Housing Material

Aluminium proile with plastic outer casing (PVC)

Housing Dimensions

197 mm x 58 mm x 47 mm (L x W x H)

Weight (net /gross)

Approx. 340 g / 1250 g

*FS = Full Scale

ETMB Guide Rollers:

ETMPB Guide Pins:

V - grooved

Line Speed

m/min max.

Roller

Material

Standard

2000

Aluminium

hard

chromed

V - grooved

Line Speed

m/min max.

Pin

Material

Standard

6000

Oxide

ceramic

This manual is related to the following products: